Plastic T8 g13 fluorescent starter holder specification:
Model: JMS-LL03-2
Weight：4.5g
Package：200pcs
Quality Certification: CE/RoHS/CQC
Light source: tubular fluorescent lamps
Light source power :4-80 (W)
Heat: T110 ° C
Withstand voltage: 2A / 250 V
G13 fluorescent starter holder Scope: Grille, bracket lamp, three anti-light, clean lighting.
A fluorescent starter holder T8 is an electrical component used in fluorescent light fixtures to hold the starter, which triggers the lamp to ignite.
When the switch is turned on, the starter’s contacts close, allowing electrical current to flow through the tube’s filaments. This heats up the gas inside the tube, causing it to glow and produce light.
fluorescent starter holder, currently a mechanical starter fluorescent lamp, in use for some time, the tube ends blackening phenomenon appears to affect lamp life. The electronic starter for fluorescent lamp starter circuit is determined by the rectifier regulator circuit, self-protection circuit, a timing circuit and starter circuit components.
After power on, when the starter circuit received from the timing circuit working after a signal lamp is lit.
The utility model, compared with the prior art, with a low failure rate, wide operating voltage range, so that the lamp and long service life.
High-performance electronic starter, fast starter big, small diameter fluorescent lamps, with starter performance, non-contact, long life, fast starter, a characteristic that the light is a kind of practical value new electronic quick starter.
FAQ:
What is the material of the fluorescent starter holder T8?
The fluorescent starter holder T8 is typically made of high-quality plastic or other non-conductive materials.
What are the dimensions of the fluorescent starter socket T8?
The fluorescent starter socket T8’s dimensions vary based on the manufacturer’s design, but it typically has a diameter of around 1 inch and a length of around 2 inches.
What is the maximum voltage and current rating of the fluorescent starter socket T8?
The maximum voltage rating of the fluorescent starter socket T8 is usually around 250 volts, and the maximum current rating is typically around 2 amps.
Can the fluorescent starter holder T8 be used with other types of fluorescent lamps?
The fluorescent starter holder T8 is designed specifically for use with T8 fluorescent lamps and is not compatible with other types of fluorescent lamps.
How do I install the fluorescent starter holder T8?
To install the fluorescent starter holder T8, you need to disconnect the power supply, remove the old starter holder, connect the wires to the new holder, and secure it in place.
Are fluorescent starter sockets T8 reusable or disposable?
Fluorescent starter sockets T8 are typically reusable and can be replaced when needed.
What are the common problems associated with fluorescent starter sockets T8?
The most common problems associated with fluorescent starter sockets T8 include loose connections, damaged wiring, and worn-out contacts. These issues can lead to flickering, dimming, or complete lamp failure.
